Waters Network Systems ProSwitch-Quad Series Especificaciones Pagina 243

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 469
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 242
Virtual Private Networking Using IPSec and L2TP Connections
243
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Traffic Selection
Local IP From the drop-down list, select the address or addresses that are part of the
VPN tunnel on the VPN firewall:
Any.
All computers and devices on the network. Note that you cannot select
Any for both the VPN firewall and the remote endpoint.
Single
.
A single IP address on the network. Enter the IP address in the Start
IP Address
field.
Range.
A range of IP addresses on the network. Enter the starting IP
address in the Start IP
Address field and the ending IP address in the End
IP Address field.
Subnet.
A subnet on the network. Enter the starting IP address in the Start
IP Address
field. In addition:
- Subnet Mask. For IPv4 addresses on the IPv4 screen only
, enter the
subnet mask.
- IPv6 Prefix Length. For IPv6 addresses on the IPv6 screen only
, enter
the prefix length.
Remote IP From the drop-down list, select the address or addresses that are part of the
VPN tunnel on the remote endpoint. The selections are the same as for the
Local IP drop-down list.
Manual Policy Parameters
Note:
These fields apply only when you select Manual Policy as the policy type. When you specify the
settings for the fields in this section, a security association (SA) is created.
SPI-Incoming
The Security Parameters Index (SPI) for the inbound policy
. Enter a
hexadecimal value between 3 and 8 characters (for example, 0x1234).
Encryption Algorithm From the drop-down list, select one of the following five algorithms to negotiate
the security association (SA):
3DES. T
riple
DES. This is the default algorithm.
None. No encryption algorithm.
DES. Data Encryption Standard (DES).
AES-128. Advanced
Encryption
Standard (AES) with a 128-bit key size.
AES-192. AES with a 192-bit key size.
AES-256
. AES with a 256-bit key size.
Key-In The encryption key for the inbound policy
. The length of the key depends on the
selected encryption algorithm:
3DES. Enter 24 characters.
None. Key does not apply
.
DES. Enter 8 characters.
AES-128
. Enter 16 characters.
AES-192. Enter 24 characters.
AES-256. Enter 32 characters.
Table 56. Add New VPN Policy screen settings for IPv4 and IPv6 (continued)
Setting Description
Vista de pagina 242
1 2 ... 238 239 240 241 242 243 244 245 246 247 248 ... 468 469

Comentarios a estos manuales

Sin comentarios